Aquasana AQ-UV-10C Инструкции по эксплуатации и установке - Страница 5
Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и установке для Системы фильтрации воды Aquasana AQ-UV-10C. Aquasana AQ-UV-10C 16 страниц. Whole house uv filter
Также для Aquasana AQ-UV-10C: Руководство пользователя (20 страниц)
Печатать страницу
Before You Begin
The following will be needed for installing the UV system:
Tools
• Pipe cutter, hacksaw or other specialized tools required to cut into your existing
plumbing (e.g. if you have PEX piping)
• Wrench (for tightening fittings)
Other Materials
• Inlet/outlet connections
• Plumber's tape
Water Quality Parameters
UV disinfection is extremely effective against microorganisms but only if the UV
light can pass through the water it needs to treat. This means that the quality of
your water is very important in order to ensure complete disinfection.
Treated water should be tested for at the least the parameters listed below. If
the water exceeds the listed parameters Aquasana strongly recommends that
appropriate pretreatment equipment be installed (equipment required will depend
on parameters being treated):
Manganese (Mn): <0.05 ppm (0.05 mg/L)
Tannins (organics): <0.1 ppm (0.1 mg/L)
UVT (transmittance): >85%
You can have your water tested at a private analytical laboratory or by your local
dealer. It is always recommended to install pre-filtration of at least 5 microns prior
to an Aquasana UV disinfection system.
Hardness: <7 gpg (120 mg/L) – if hardness level is 7 gpg or
slightly below the quartz sleeve must be cleaned
periodically in order to ensure efficient UV
penetration; if above the water must be softened.
Iron (Fe): <0.3 ppm (0.3 mg/L)
Turbidity: < 1 NTU
5