Aquasana EQ-AST-WH Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Системы фильтрации воды Aquasana EQ-AST-WH. Aquasana EQ-AST-WH 12 страниц. Whole house salt-free water conditioner
Также для Aquasana EQ-AST-WH: Инструкции по установке (5 страниц), Руководство пользователя (12 страниц)
Печатать страницу
INSTALLATION STEPS
4
1
Pre-Condition Salt-Free Water Conditioner
NOTE: It's imperative that this system is flushed properly prior to final installation.
1. Once out of the box, keep the tank upright
at all times as to not apply pressure to
divider. Remove shipping caps from inlet
and outlet ports. Using supplied adapter,
connect a garden hose to the inlet port
so the water will flow into the system
and out of the outlet port.
2. Slowly turn faucet on and allow
discolored water to flow from
outlet into a suitable
drainage area.
TIP: You may need to slightly shake
the tank to help flush the system.
3. Flush the tank for 5-10 minutes.
4. Disconnect the system from the garden
hose, be sure the white washers are
properly set inside the inlet and outlet
ports, and position the system
for installation.
Select Location
2
1. Pick an appropriate installation location. Unit must be installed in an
area where the main water line enters your home, before connecting
to the water heater.
2. Turn off the main water source prior to installation. Drain water from
lines to relieve pressure by turning on a faucet inside your home.
NOTE: DO NOT install after the water heater or on the
hot water line. Components and installation will vary.