Panasonic WV-NP502 Руководство по установке - Страница 24

Просмотреть онлайн или скачать pdf Руководство по установке для Видеокамера Panasonic WV-NP502. Panasonic WV-NP502 32 страницы. Ip video cameras
Также для Panasonic WV-NP502: Сравнительная таблица (6 страниц), Примечание по интеграции (8 страниц)

Panasonic WV-NP502 Руководство по установке
When using 12 V DC power supply
q Loosen the screw of the power cord plug (accessory).
w Connect the cable of the 12 V DC power supply to the
power cord plug.
Strip 3 mm - 7 mm from the end of the wire, and twist
the stripped part of the wire sufficiently to avoid short cir-
cuit.
Specification of cable (wire): 16 AWG - 28 AWG,
Single core, twisted
• Check whether the stripped part of the wire is not
exposed and is securely connected.
e Tighten the screw of the power cord plug.
r Connect the power cord plug to the 12 V DC power sup-
ply terminal on the rear of the camera.
Important:
• Be sure to fully insert the power cord plug (accessory) into the 12 V DC power supply terminal.
Otherwise, it may damage the camera or cause malfunction.
When using PoE (IEEE802.3af compliant)
Connect an Ethernet cable (category 5 or better) between a PoE device (such as a hub) and the
network connector of the camera.
Important:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m.
• Make sure that the PoE device in use is compliant with IEEE802.3af standard.
• When connecting both the 12 V DC power supply and the PoE device for power supply, PoE
will be used for power supply.
• When disconnecting the LAN cable once, reconnect the cable after about 2 seconds. When
the cable is quickly connected, the power may not be supplied from the PoE device.
24
10BASE T/100BASE-TX
AUDIO OUT
MIC/LINE IN
ACT
LINK
SD CARD/ABF
MONITOR OUT
12V = IN
EXT I/O
GND 4 3 2 1
ALARM IN 1/DAY/NIGHT IN
ALARM IN 3/
AUX OUT/EXPOSURE OUT
ALARM IN 2/ALARM OUT
To 12 V DC
power supply
12 V DC power
cord plug
(accessory)
(GND)
INITIAL
SET
POWER
(12 V DC)