AQUATECH REFLEX Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для фотоаппаратов AQUATECH REFLEX. AQUATECH REFLEX 9 страниц. Sport housing
Также для AQUATECH REFLEX: Руководство по эксплуатации (5 страниц)
Печатать страницу
Zoom Gear Control
Located on the front left of our Sport Housing, this
control drive gear engages our Zoom Gear to change
the focal length of the lens, where applicable.
Lens Port
Before installing your Lens Port make sure the O Ring
is present. Then place your port inside the front Sport
Housing and turn clockwise until its secure. Remember
to seal your Lens Port very tight with both hands to
ensure a good seal on the front O-Ring between your
Lens Port and Sport Housing.
Securing the Housing
When you first receive your gear we recommend that
you do these steps without the camera and lens inside
the Sport Housing:
1. Open your Backplate and remove the port. Ensure
O-Rings and Seals are present and in the assigned
grooves.
2. Attach the Camera Plate to the bottom of your
camera and slide it into the Sport Housings Manny
Mount.
3. With the Sport Housing facing downward put the
Backplate on following the same steps detailed in the
Initial Setup.
4. Once the buttons are positioned over the cameras'
controls correctly you can then clamp down the two
safety clips, making sure the two clips are firmly locked
and your Backplate is secure.
5. Check the Main Seal to ensure that you have a nice
seal all around and that the Main Seal is not pinched.
6. When your Backplate is securely fastened, your
safety clips should be parallel with the Safety Clip
Protector. The important final check with the clip is to
pull up against it to make sure it does not come undone
and is locked. When the safety clip is locked the clip will
not release,
7. Screw your Lens Port onto the Sport Housing. Your
Port should screw on with ease and never feel as if it
is being forced. Ensure the thread on the base of your
Port and the Front of the Sport Housing are aligned.
Tighten the port clockwise making sure not to pinch the
Compression O-Ring. Before every use please repeat
these steps to make sure your Sport Housing has a
watertight seal.
Water testing
Water testing is a very important process before
entering the water in all types of conditions. Once you
have followed "Securing the Sport Housing" instructions
we recommend that you perform a water test yourself
without the camera and lens inside.
1. Fill up a bathtub, use a swimming pool or hop in the
ocean to test. The choice is yours just as long as you
have a body of water where you can fully submerge
your equipment.
2. Hold your equipment under the water for 5-10
seconds while also pressing all the buttons. Then hold
the Sport Housing above your head at a tilted angle
so that if there is any water inside it will gather at the
bottom right back corner.
5