Aquatic BLUECUBE+ AQ-BC-6UBT-X Руководство по эксплуатации и установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Медиаплеер Aquatic BLUECUBE+ AQ-BC-6UBT-X. Aquatic BLUECUBE+ AQ-BC-6UBT-X 18 страниц. 'hide-away' media player
Печатать страницуGetting Started
1.2.1 Connections Diagram
1.3 12-pin Harness Connection (retail packaged models only)
If your AQ-BC-6UBT-X was purchased from an Aquatic AV dealer and/or supplied with retail
packaging it is supplied with the Aquatic AV universal harness AQ-UNH-2 in order to connect the
media player to power and speakers. Please proceed to section 1.3.1.
If your AQ-BC-6UBT-X was supplied as a pre-installed waterproof entertainment system it will
utilise 3rd party wiring connections and is not supplied with the Aquatic AV 12-pin Harness.
Please proceed to section 1.4
1.3.1 12-pin Harness Wiring Diagram
All open wire connections should be soldered and protected against water and dust for best long-term performance.
*Retail packaged models only.
www.aquaticav.com
12. Bridge Mode Wire (magenta)
11. Power Attenuation Wires (1x white, 1x black)
Rear channel Bridge Mode (for subwoofer operation) is
selected when the magenta wire is cut. See section 1.7.
Rear channel Bridge
Mode (for subwoofer
operation) is selected
when the magenta wire
is cut. See section 1.7.
BlueCube+ Media Player AQ-BC-6UBT-X
2. FM Radio Antenna Jack
1. 12-pin Watertight Harness*
3. RCA Auxiliary Outputs - Rear
4. RCA Auxiliary Outputs - Front
5. RCA Auxiliary Inputs
6. 12V DC Triggers (2x red, 2x red/black)
7. USB Input Connector
8. Wired Remote 8-pin DIN Connector
9. Power On LED
10. Bluetooth Halo Aerial Connector
No lower than a 2 Ohm load, or 4
Ohm in bridged mode, should be
used or damage may occur to the
BlueCube+.
Make sure the polarity of
speakers are connected correctly.
5