Olympus PFL-E01 Руководство по эксплуатации - Страница 24

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары для фотоаппаратов Olympus PFL-E01. Olympus PFL-E01 29 страниц. Electronic flash waterproof case for the fl-36

Печатать страницу

Install the O-ring

Confirm that no foreign matter is attached, apply a thin coat of the accessory grease to the O-ring, and

fit the O-ring into the groove. At this time, confirm that the O-ring does not stick out from the groove.

※This sections explains how to apply lubricant to the camera case. Use the same

procedure for the flash case.

How to Apply Grease to the O-ring

Apply the specified

grease

Spread the grease

over the O-ring.

Check that there is

no damage or

irregularities on the

O-ring.

Apply the grease to

the O-ring contact

surface.

CAUTION

：• Always perform maintenance of the waterproof function even when the Case has

been opened to exchange the battery or the image storage during shooting.

Neglecting this maintenance may become the cause of water leakage.

• When the Case is not to be used for a long time, remove the O-ring from the

groove to prevent deformation of the O-ring, apply a thin coat of silicone grease,

and store it in a clean plastic bag or the like.

• When drying is done with salt attached, it is likely that a function impairment will

be caused. After use, always wash off any salt.

Replace consumable products.

・The O-ring is a consumable product. Independent of the number of times the Case is used, it

is recommended that the O-ring should be replaced by a new one at least once a year.

・Deterioration of the O-ring is accelerated by the use conditions and the storage

conditions. Replace the O-ring even before a year has passed if it shows signs of

damage, cracking or loss of elasticity.

Note： Please use original Olympus products for the silicone O-ring grease, the silica

gel, and the O-ring. These consumable products also can be purchased at an

Olympus service station.

Make sure there is no dirt on your fingers

or on the O-ring; then squeeze about 5

mm of grease onto your fingertip.

Using two fingers and a thumb, spread

the grease over the O-ring while rubbing

it in. Use caution not to squeeze or pull

the O-ring too hard.

Once the grease has permeated throughout the

O-ring, check it for damage or irregularities (both

visually and by touch). If you notice any

abnormalities, replace the O-ring with a new one.

Use any residual grease on your fingertips

to clean and lubricate the O-ring contact

surface on the front lid.

E-22