Axon Synapse HDR07 Техническое руководство - Страница 11
Просмотреть онлайн или скачать pdf Техническое руководство для Усилитель Axon Synapse HDR07. Axon Synapse HDR07 18 страниц. Re-clocking hdsdi distribution amplifiers
Печатать страницу5 Settings Menu
Introduction
The settings menu displays the current state of each setting within
the HDR07 and enables the item to be changed or adjusted.
Settings can be changed using the front panel of the Synapse
frame (SFR18, SFR08 or SFR04) or Axon Cortex software.
PLL_Set
The HDR07 is capable of re-clocking a range of SDI and HDSDI
transport stream bitrates. PLL_Set is used to set the HDR07 to
the correct bitrate of the incoming SDI or HDSDI signal.
PLL_Set can be set to Autodetect, 143Mb/s, 177Mb/s,
270Mb/s, 360Mb/s, 540Mb/s and 1485Mb/s.
The default setting is Autodetect.
Reclock
The setting item Reclock determines if the incoming signal will
be reclocked by the HDR07. The settings are;
Auto
selection
between
and
Automatic:
Bypass
Reclocked.
Bypass: Does not re-clock the incoming signal
Reclocked: The HDR07 always attempts to re-clock the
incoming signal.
The default setting is Automatic.
ASI_177
The setting item ASI_177 allows an incoming signal of 177Mb/s
to be handled. When ASI_177 is switched Off an incoming
signal with a bit rate of 177Mb/s will not be detected by
PLL_Set.
The Default setting is On.
DDOmute
DDOmute (Direct Digital Out mute) enables the outputs of the
HDR07 to be muted. The settings are On, Off, Input Loss or
PLL Unlock. Set to Input Loss will mute only in case a
carrier loss is detected on the input. Set to PLL unlock will
mute the outputs in case the PLL rate of the input is not available.
The Default setting is Off.
9