AXVAC TEC 7300 Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Клеевой пистолет AXVAC TEC 7300. AXVAC TEC 7300 12 страниц.

Genetic guidelines

• Avoid air pressure settings above 7 bars as this can

damage the spray gun

• Only use VACTAC200 hot melt adhesive with the

spray gun. New adhesives will need to be qualified by

R&D before use

• NEVER leave the gun lying on its side while turned

on. This will cause adhesive to run back into the

chamber and jamming the gun.

• Prevent contamination of the adhesive slugs.

Particles in or on the adhesive slugs can block the

nozzle of the spray gun.

• Always follow current guidelines for adhesive dosage.

Over dosage can cause delamination's.

• Always consult AXVAC before potential changes of

nozzle type.

• Hot melt adhesive should not be used for full surface

joining.

• For large glass pieces it is recommended to join fix-

points in the glass and adhere the fabrics from these

inside the mould as opposed to applying adhesive to

the entire ply outside the mould.