Cisco AJ732A - MDS 9134 Fabric Switch Примечание к выпуску - Страница 16

Просмотреть онлайн или скачать pdf Примечание к выпуску для Переключатель Cisco AJ732A - MDS 9134 Fabric Switch. Cisco AJ732A - MDS 9134 Fabric Switch 22 страницы. Converged network switches for nx-os 4.0(1a)n1(1)
Также для Cisco AJ732A - MDS 9134 Fabric Switch: Руководство по конфигурации (49 страниц), Примечание к выпуску (48 страниц), Примечание к выпуску (44 страниц), Примечание к выпуску (44 страниц), Примечание к выпуску (36 страниц), Примечание к выпуску (26 страниц), Краткое справочное руководство (14 страниц), Примечание к выпуску (3 страниц)

switch# config terminal

4. Enter the following command to enter the VSAN database:

switch(config)# vsan database

5. Enter the following command to enable the VSAN(s) that contain the Continuous Access

EVA and/or DRM fabric to src-dst-id loadbalancing:

switch(config-vsan-db)# vsan <1-4094> loadbalancing src-dst-id

switch(config-vsan-db)# exit

switch(config)# exit

6. Verify that src-dst-id is enabled for the desired VSAN by entering the following

command:

switch# show vsan <1-4094>

In the following example, VSAN 1 loadbalancing is set to src-id/dst-id

switch# show vsan 1

vsan 1 information

name: vsan1

interoperability mode: default

loadbalancing: src-id/dst-id

operational state: up

7. Type the following to copy the running configuration into the startup configuration:

switch# copy running-config startup-config

Refer to the Cisco MDS 9000 Family Fabric Manager Switch Configuration Guide to set

src-dst-id using Device/Fabric Manager.

Note: The running configuration overwrites the startup configuration.

C-SERIES MDS 9020 FABRIC MANAGEMENT

The C-series MDS 9020 can be managed through the CLI or the Cisco MDS 9000 Family

Fabric/Device Manager tool using Simple Network Management Protocol (SNMP). FabricWare

2.1(3) supports SNMP v1 and SNMP v2. When using Fabric/Device Manager with SNMP v3

enabled, all C-series MDS 9020 configurations must be saved using either the CLI or Device

Manager. In an environment where there is a co-existence of switches running SAN-OS and

FabricWare, Fabric Manager will only save SAN-OS configurations. To save MDS 9020 switch

configurations, the CLI or Device Manager must be used in order to avoid possible inconsistency

or fabric segmentation.

Note: WWPN (FLOGI) information can not be obtained for the MDS 9020 using Device Manager.

CHANGING PORT SPEED ON THE C-SERIES MDS 9020

If required, use the following CLI procedure to change the port speed setting on the C-series

MDS 9020:

state: active

MDS Multilayer Director & Multilayer Fabric Switches Release Notes