Digisol DG-GS4600SE2 Series Руководство по установке - Страница 18
Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель Digisol DG-GS4600SE2 Series. Digisol DG-GS4600SE2 Series 20 страниц. Giga layer 3 switches
2.3.4 SFP+ extended module Installation
DG-GS4600SE2 series provide 10Gb slots. The procedure for installing the SFP+
10Gb fiber transceiver is shown below:
Step 1: Put on an ESD wrist strap (or antistatic gloves).
Step 2: Insert the SFP+ transceiver to the 10G optical port. Do not put the SFP+
transceiver up-side-down.
Step 3: Push the SFP+ transceiver gently until the optical module is mixed with the optical
port.
Note: the SFP+ 10Gb fiber transceiver is hot swappable.
Caution!
Do not stare directly at the 2 fiber bores in the fiber transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.
2.3.5 Copper Cable/Fiber Cable Connection
Copper cables should be connected as below:
Step 1: Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the copper cable
line card of the switch;
Step 2: Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of other
device;
Step 3: Check all status indicators for the corresponding ports; a lighted LED indicates
that the link has been established, otherwise the link is not ready and the cable should be
examined.
Caution!
Please verify the sign above the port to ensure the right port used. Connecting to wrong
ports might damage the switch.
Fiber cables should be connected as below:
Step 1: Remove the protective plug from the SFP/SFP+ fiber transceiver bore; Remove
the protective cap from one end of the fiber cable. Keep the fiber end clean and neat.
Step 2: Attach one end of the fiber cable to the SFP/SFP+ transceiver, and attach the
other end to the transceiver of the corresponding devices. Note: The SFP/SFP+
DG-GS4600SE2 Installation Guide
Chapter 2-8