DIGISYNTHETIC DSP2200E Руководство пользователя - Страница 10

Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель DIGISYNTHETIC DSP2200E. DIGISYNTHETIC DSP2200E 18 страниц. Integrated dsp power amplifier

DIGISYNTHETIC DSP2200E Руководство пользователя
4. Establish the Communication Connect
Select Connect button to open the Connect window. Fill in the Add and/or Sub Add
to select the unit. Click Connect to go
parameters of gain,EQ, crossover, delay, compress/limit, mode etc..
The Address (main ID) is from 1 to 255 that can be setup by the user freely. The Sub
Address (slave ID) is from 1 to 65536 that is preset in the factor y and can t be changed.
The Sub Address will display each time the unit powers on or press the left jog-wheel
after turning on.
The unit is mute (default) if mute is selected by clicking the MUTE checkbox, otherwise
the unit gain remains.
Disconnect means the unit connecting goes out of the PC control. The unit will reload
the program automatically while disconnect. The gain will escalate gradually up to
the program gain if the program gain is not mute and AUTO MUTE is OFF (refer to SETUP
VOLUME PROTECT in amplifier manual).
NOTE:
The user must fill in Sub Add (slave ID) to connect the unit if two or above units with
the same Add (master ID). Otherwise the system would connect all the units with
the same Add (master ID) to cause communication malfunction.
If no units have the same Add (master ID), the user can connect the units without
Sub Add (slave ID) setup.
The present connect unit disconnects automatically every time connecting a
new unit.
online ,
, Then you can adjust the amplifier s
'
9