Cisco Webex 840 Настройка - Страница 4

Просмотреть онлайн или скачать pdf Настройка для IP-телефон Cisco Webex 840. Cisco Webex 840 10 страниц. Wireless phone
Также для Cisco Webex 840: Краткое справочное руководство (3 страниц), Руководство по устранению неполадок (6 страниц), Руководство (12 страниц), Руководство (36 страниц), Краткое справочное руководство (3 страниц), Краткое справочное руководство (3 страниц)

Battery Hot Swap for 860 Phones

Procedure

Step 1

To disengage the battery clip, gently use a fingernail to depress the clip towards the top of the phone.

Caution

Step 2

Use your fingernail to lift the battery gently about an eighth of an inch (a few millimeters) out of the battery

compartment.

Step 3

Release the battery clip and grab the battery with your fingers.

Step 4

Use the battery tabs and battery compartment slots as a pivot point to raise the battery edge out the battery

compartment.

Warning

Step 5

Gently withdraw the battery tabs from the battery compartment slots and lift the battery out of the battery

compartment.

Warning

Battery Hot Swap for 860 Phones

The Cisco Webex Wireless Phone 860 and Cisco Webex Wireless Phone 860S have a hot swap feature that

allows you to continue to use your phone while you change a low battery. During a hot swap, the 860 internal

phone battery provides minimum power to allow the phone to remain on. Active use of the phone or anything

that increases the power draw during a swap may, in rare situations, cause the phone to power off.

After you remove the battery, you have 60 seconds to replace the battery before the phone starts to shut down.

Phone Setup

Don't pull up on or twist the clip. Don't use a tool, such as letter opener or screwdriver, to pry the

clip open. An incorrect prying action with a tool can break the battery clip.

Don't slide the battery across the battery compartment because this action may damage the contacts.

Make sure that no part of the battery drags across the battery contacts in the phone.

Phone Setup