Cisco WUMC710 Руководство пользователя - Страница 15
Просмотреть онлайн или скачать pdf Руководство пользователя для Сетевой маршрутизатор Cisco WUMC710. Cisco WUMC710 17 страниц. 802.11ac
Также для Cisco WUMC710: Руководство по быстрой установке (17 страниц), Руководство пользователя (17 страниц)
Печатать страницу
Linksys WUMC710
Troubleshooting
WUMC710
Your computer or other wired, Ethernet device cannot communicate with the
wireless router.
1. Access the media connector's browser-based utility
2. On the Basic Wireless Settings screen, make sure the Network Name (SSID)
matches the name of your wireless network
3. Make sure the security settings (WPA, WPA2, or WEP) match the security
settings of your wireless network
The media connector's IP address needs to be changed.
If the media connector is connected to a network with a DHCP server (usually
the network router), then the media connector will obtain its IP address from
the DHCP server If there is no DHCP server, then the media connector will use
its default, static IP address, 10.100.1.1
If you want the media connector to always use a static IP address, then follow
these instructions:
1. Access the media connector's browser-based utility
2. Click the Setup tab, then open the Basic Setup page
3. From the Network Setup drop-down menu, select Static IP
4. Complete the Static IP Address, Subnet Mask, and Default Gateway fields
5. Click Save Settings
The media connector-enabled computer or other wired, Ethernet device will
not communicate with another wireless-enabled device (such as a computer
or printer).
Check the following:
Make sure the wireless-enabled device is on the same wireless network
•
as the computer or other wired, Ethernet device connected to the media
connector
Make sure that the same Network Name (SSID) is used for all devices on
•
the wireless network
Make sure all devices are on the same IP network, using compatible IP
•
addresses
The browser-based utility does not accept your password.
Check the following:
The password is case-sensitive Make sure that you are using the correct
•
case(s) when entering the password
If you forget your password, you can reset the media connector to its
•
factory defaults
Press and hold the media connector's Reset button for approximately
five seconds; the password will be reset to its factory default, admin All
other media connector settings will be reset to the factory defaults as
well (To access the browser-based utility, enter admin in the Password
field )
After you make changes through the browser-based utility, the new settings
are not displayed on-screen.
On your web browser, click Refresh If the new settings are not displayed, then
follow these instructions:
1. Unplug the power adapter from the media connector
2. Wait five seconds, and then plug the power adapter back into the media
connector
3. On your web browser, click Refresh
WEB
If your questions are not addressed here, refer to the Linksys
website at Linksys.com/support
Troubleshooting
14
14