Cisco UCS B420 M3 Руководство по обновлению - Страница 3
Просмотреть онлайн или скачать pdf Руководство по обновлению для Сервер Cisco UCS B420 M3. Cisco UCS B420 M3 8 страниц. High performance blade server
Также для Cisco UCS B420 M3: Указания по установке и обслуживанию (38 страниц)
Печатать страницу
Upgrade Scenario 1: UCSM and BIOS Earlier Than Version 2.2(2c), CPU Earlier Than Intel E5-4600 v2
This scenario assumes the following conditions:
•
•
•
In this case, use the following procedure to upgrade the server and CPUs.
Upgrade the Cisco UCS Manager software to version 2.2(2c) or later. The required server CIMC and
Step 1
BIOS are also included with the 2.2(2c) download bundle.
Use the procedures in the appropriate upgrade guide for Release 2.1 (depending on your current software
version):
Use Cisco UCS Manager 2.2(2c) to upgrade and activate the server CIMC to version 2.2(2c) or later.
Step 2
Use the GUI or CLI procedures in the
Use Cisco UCS Manager 2.2(2c) to upgrade and activate the server BIOS to version 2.2(2c) or later.
Step 3
Use the GUI or CLI procedures in the
Disassociate the server in Cisco UCS Manager.
Step 4
Step 5
Power off the server.
Step 6
Replace the CPUs with the Intel E5-4600 v2 Series CPUs.
Use the procedures in the
Reinsert the server to the chassis.
Step 7
Wait for Cisco UCS Manager to automatically discover the server.
Step 8
Note
Clear the WILL_BOOT_FAULT
Step 9
a.
b.
c.
d.
e.
Upgrade Scenario 2: UCSM and BIOS at Version 2.2(2c) or Later, CPU Earlier Than Intel E5-4600 v2
This scenario assumes the following conditions:
•
OL-28629-01
The Cisco UCS Manager software is at a version earlier than 2.2(2c).
The server is at a BIOS/CIMC version earlier than 2.2(2c).
The server is using CPUs earlier than Intel E5-4600 v2 Series.
UCS Manager Install and Upgrade
Blade Server Installation and Service Note
At this point, the Health LED of the server shows a critical fault and Cisco UCS Manager reports
a generic error message:
controller activation is required, as described in the next step.
In the Navigation pane, click the Equipment tab.
On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose
your server.
In the Work pane, click the General tab.
In the Actions area, click Recover Server.
In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.
Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This
takes two to three minutes. At the end of this process the WILL_BOOT_FAULT is cleared.
The Cisco UCS Manager software is at version 2.2(2c) or later.
Guides.
UCS Manager Install and Upgrade Guides.
UCS Manager Install and Upgrade Guides.
WILL_BOOT_FAULT: Sensor failure asserted
using the Cisco UCS Manager GUI to reset the server CIMC:
by
Cisco UCS B420 M3 Server Upgrade Guide for Intel E5-4600 v2 Series CPUs
Cisco UCS Blade Server
for your server.
. This is because a board
3