Cisco ASR 5000 Руководство по установке - Страница 24

Просмотреть онлайн или скачать pdf Руководство по установке для Шлюз Cisco ASR 5000. Cisco ASR 5000 33 страницы. Applying power and verifying the installation
Также для Cisco ASR 5000: Руководство по установке (18 страниц), Процедура установки (8 страниц), Руководство по установке (37 страниц)

Halting Cards

You will receive the following prompt:

Are You Sure? [Yes|No]:

For a complete description of the above command, see the Exec Mode Commands chapter of the Command line Interface

Reference.

Step 2

Press Y to start the switch.

Step 3

Verify that the migration was successful by entering the following command:

host_name

[local]

Check the entry in the Oper State column next to the line card or SPIO that was just switched from. Its state should be

Standby. The state of the line card or SPIO switched to should be Active.

Halting Cards

Packet processing cards or line cards that are in either the active or standby modes can be halted. Halting these

cards places them into the "offline" mode. In this mode, the card is unusable for session processing as either

an active or redundant component.

If a card in the active mode is halted, its tasks, processes, or network connections will be migrated to a redundant

component prior to entering the offline mode.

This section describes how to initiate a card halt and restore halted components.

Follow the instructions below to manually initiate a card halt. These instructions assume you are at the root

prompt for the Exec mode.

Step 1

Initiate a manual card migration by entering the following command:

host_name

[local]

slot# is the chassis slot number in which the card to be halted is installed. It can be any integer value between 1 and 7,

10 through 48. You will receive the following prompt:

Are You Sure? [Yes|No]:

Step 2

Press Y to initiate the halt operation.

Step 3

Verify that the migration was successful by entering the following command:

host_name

[local]

Check the entry in the Oper State column next to the line card that was just halted. Its state should be Offline. If the card

was in active mode prior to the execution of this command, the state of the redundant component associated with it

should now be Active.

ASR 5000 System Administration Guide, StarOS Release 21.2

show card table

card halt slot#

show card table

Troubleshooting