Epson FX-880+ Краткое руководство - Страница 19

Просмотреть онлайн или скачать pdf Краткое руководство для Аксессуары для принтеров Epson FX-880+. Epson FX-880+ 33 страницы. Epson serial impact dot matrix printers
Также для Epson FX-880+: Руководство по настройке (33 страниц), Брошюра и технические характеристики (24 страниц), Руководство (18 страниц), Технические характеристики (2 страниц), Сначала прочитайте это (2 страниц), Справочное руководство (34 страниц)

Печатать страницу
Epson FX-880+ Краткое руководство
3. Pull both paper set levers forward until
the paper guides retract and lock open to
allow paper loading.
4. Take a stack of paper (up to 50 sheets)
and fan it. Next, tap the side and bottom
edges of the paper on a flat surface to
even up the stack.
5. Insert the paper stack printable side
down along the left paper guide.
6. Adjust the right paper guide so that it
matches your paper's width. Make sure
the position of the guide allows the
paper to move up and down freely.
7. Push back the paper set levers to clamp
the paper against the guide rollers.
Downloaded from:
http://www.usersmanualguide.com/
EPSON FX-880+/FX-1180+ Quick Guide
8. Attach the stacker-support wires to the
paper guide as shown below, if
necessary.
9. Install the paper guide with the attached
stacker-support by fitting the notches on
the paper guide straight down over the
mounting posts on the printer. Slide the
edge guides to the middle of your paper.
The cut-sheet feeder automatically loads
paper when the printer receives data.
If the first line on your page appears too high
or low, you can adjust its position using the
Micro Adjust function. See "Micro Adjust
Function."
Single Sheets with the Single-Bin Cut-Sheet Feeder (2/2)