Whirlpool AWM 8000/PRO Руководство по установке - Страница 5
Просмотреть онлайн или скачать pdf Руководство по установке для Стиральная машина Whirlpool AWM 8000/PRO. Whirlpool AWM 8000/PRO 6 страниц.
Также для Whirlpool AWM 8000/PRO: Руководство по установке (40 страниц)
Печатать страницу
CONNECT THE WATER INLET HOSE
7. - If the water inlet hose is not already installed,
it must be screwed to the appliance.
If your washing machine has one inlet valve on
the back: connect it to cold fill only.
8. - If your washing machine has two inlet valves
on the back, you must connect both valves
to the water supply:
• either connect red inlet valve to hot fill tap and
blue inlet valve to cold fill tap.
• or connect both inlet valves to cold water tap by
using a Y-adapter.
Make sure all connections are tightly fixed.
Screw the inlet hose by hand to the tap and to the
inlet valve and tighten the nut. Do not use any
tools for fixing the inlet hose.
Attention
• No kinks in the hose!
• The appliance must not be connected to the mixing tap of an un-pressurized water
heater.
• Check water-tightness of connections by turning the tap completely on.
• If the hose is too short, replace it with a suitable length of pressure resistant hose
(1000 kPa min, EN 50084 approved type).
• Check the inlet hose regularly for brittleness and cracks and replace if necessary. It is
generally recommended to renew the inlet hose every 3 years.
• The washing machine can be connected without a non-return valve.
- For models with Water Stop hose:
If the flexible hose is too short, replace it with a longer Water Stop
hose available through our After-Sales Service or from your dealer.
The replacement must be carried out by an expert. While unscrewing
the water stop hose, the release lever must be pushed down.
Cold fill
Hot fill
Blue inlet valve
Red inlet valve
Y-adapter
release lever
Cold fill
5