ABB AutoLink Инструкции по монтажу - Страница 6

Просмотреть онлайн или скачать pdf Инструкции по монтажу для Устройство защиты ABB AutoLink. ABB AutoLink 11 страниц. 15kv, 27kv, 38kv
Также для ABB AutoLink: Книга инструкций (12 страниц)

Печатать страницу

TEHI95094 – rev. 1

For special installation requirements or other operating conditions, please contact ABB.

6.3 Initial Setting or Previous Setting Modification Instructions

Remove the contact cap (Fig. 1 A) with a 34mm fork spanner holding the base (Fig. 1 B)

with the hand. Check condition of O-ring (Fig. 2 E), and replace if necessary, applying

grease on it.

Figure 1

With a small screwdriver, set the dip switches for calibrating current (Fig. 2 C, 4 switches)

and Counting Operations (Fig. 2 D, 2 switches), according to settings table 1.

Note: handle with care without forcing the switches. Settings must be made in a clean

and dry environment.

Figure 2

IEC 60694

IEC 61936: Electrical Installation

ANSI C37 63: Automatic Sectionalizer

All accident prevention regulations in force in relative countries

6 / 11