Zanussi ZWS 688 Руководство пользователя - Страница 20

Просмотреть онлайн или скачать pdf Руководство пользователя для Стиральная машина Zanussi ZWS 688. Zanussi ZWS 688 24 страницы.

Печатать страницу

After removing all the

packaging, carefully

lay machine on it's

back to remove the

polystyrene base from

the bottom.

Unscrew the three

bolts.

Fill the smaller upper hole and the two large

ones with the corresponding plastic plug caps

supplied in the bag containing the instruction

booklet.

Positioning

Install the machine on a flat hard floor. Make

sure that air circulation around the machine is

not impeded by carpets, rugs etc. Check that

the machine does not touch the wall or other

kitchen units. Level the washing machine by

raising or lowering the feet. The feet may be

tight to adjust as they incorporate a self locking

nut, but the machine MUST be level and stable.

Remove the power

supply cable and the

hoses from the hose

holders on the rear of

the appliance.

Slide out the relevant

plastic spacers.

Any necessary adjustment can be made with a

spanner.

Accurate levelling prevents vibration, noise and

displacement of the machine during operation.

Never place cardboard, wood or similar materi-

als under the machine to compensate for any

unevenness in the floor.

Water inlet

Caution!

• This appliance must be connected

to a cold water supply.

• Before connecting up the appliance to

new pipework or to pipework that has

not been used for some time, run off a

reasonable amount of water to flush out

any debris that may have collected.

• Do not use the hose from your previous

appliance to connect to water supply.

The inlet hose is supplied with the appliance

and can be found inside the machine drum.

35°

If necessary, check

the setting with a spi-

rit level.

45°