Zanussi ZT 6910 Книга инструкций - Страница 15
Просмотреть онлайн или скачать pdf Книга инструкций для Посудомоечная машина Zanussi ZT 6910. Zanussi ZT 6910 28 страниц. Zanussi dishwasher instruction book
Также для Zanussi ZT 6910: Книга инструкций (28 страниц)
Печатать страницу
Operating sequence
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Press the ON-OFF push
button
The display will show the last selected
programme (if programme options have been
selected the corresponding lights will
illuminate).
3. Check that there is rinse aid
and salt
The corresponding indicator lights will
illuminate if refilling is necessary.
4. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the
saucepans, plates and cutlery in it.
Pull the upper basket out and arrange the
plates, saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
5. Ensure that the spray arms
can rotate freely.
6. Measure out detergent
Add the required amount of detergent into the
dispenser.
Important!
If the half load option is selected
remember to reduce the quantity of
detergent.
Close the detergent dispenser lid.
7a. Setting and starting the
programme without "DELAY
START"
The selection of the programme occurs with
the door partially opened.
All manuals and user guides at all-guides.com
15
Press the "PROGRAMMES SELECTION" push
button until the required programme number
appears in the digital display (see "Washing
programmes" chart).
To see the duration of the programme (in
minutes), only with open door, press the
"CANCEL" push button
The following options may also be selected:
HALF LOAD: by pressing the corresponding
push button
ECO DRY or NO DRY by pressing the
corresponding push button.
Close the door, the programme will start
automatically and an audible signal advises
you of this.
All the indicator lights will turn off.
The display will show the running time of the
programme.
7b. Setting and starting the
programme with "DELAY
START"
Once a programme and required options have
been selected (see point 7a.) to use DELAY
proceed as follows:
Press the DELAY push button.
The digital display will show "h 0".
If other options have been selected the
corresponding indicator lights will turn off, but
this will not modify the settings made previously.
Press the button again to select the number of
hours by which you wish to delay the programme
start (up to a maximum of 12 hours).
To set the time setting to zero press the DELAY
push button until "h 0" appears in the digital
display.
Close the door, an audible signal will confirm
the starting of the countdown.
The digital display shows the delay time, which
will decrease in steps of 1 hour.
The progression of the countdown will be
confirmed by a flashing dot in the digital display.
Once the delayed time has elapsed the
programme will start automatically and in the
digital display will appear the duration of the
programme.
The opening of the door will not stop the
countdown.