Zanussi ZFT10210WA Руководство пользователя - Страница 10
Просмотреть онлайн или скачать pdf Руководство пользователя для Морозильная камера Zanussi ZFT10210WA. Zanussi ZFT10210WA 17 страниц.
Также для Zanussi ZFT10210WA: Руководство пользователя (16 страниц)
Печатать страницу
Problem
Door does not open easily.
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
CLOSING THE DOOR
1. Clean the door gaskets.
INSTALLATION
WARNING! Refer to Safety chapters.
POSITIONING
Install the appliance in a dry, well ventilated indoors
where the ambient temperature corresponds to the
climate class indicated on the rating plate of the
appliance.
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Some functional problems might occur
for some types of models when
operating outside of that range. The
correct operation can only be
guaranteed within the specified
temperature range. If you have any
doubts regarding where to install the
appliance, please turn to the vendor,
to our customer service or to the
nearest Authorised Service Centre.
10
Possible cause
There is no cold air circulation
in the appliance.
You attempted to re-open the
door immediately after closing.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Authorised Service
Centre.
LEVELLING
When placing the appliance ensure that it stands
level. This can be achieved by two adjustable feet
at the bottom in front.
LOCATION
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below
overhanging wall units. Accurate levelling is
Solution
Make sure that there is cold air
circulation in the appliance.
Wait a few seconds between
closing and re-opening of the
door.
It must be possible to disconnect the
appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.