Alemite 586-C Инструкции по эксплуатации и техническому обслуживанию - Страница 9

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Инструменты Alemite 586-C. Alemite 586-C 16 страниц. Cordless grease gun (battery charger included)

Alemite 586-C Инструкции по эксплуатации и техническому обслуживанию

Load gun

NOTE
Refer to Fig. IPB 1, page 13 for compo-
nent identification in the following
procedures.
Cartridge load
1 Unscrew grease cylinder (33) from gun.
2 Pull follower rod and engage groove in
follower rod with slot in grease
cylinder cap.
3 Remove plastic cap from cartridge.
4 Apply film of grease to exposed inside sur-
face of cartridge.
NOTE
This is only necessary for a new gun.
5 Insert cartridge into grease cylinder.
6 Remove tabbed seal from cartridge.
7 Screw grease cylinder onto gun.
8 Disengage follower rod from slot in grease
cylinder cap.
9 Push follower rod into grease cylinder.
Suction load
1 Unscrew grease cylinder (33) from gun.
2 Insert head of grease cylinder below
surface of grease.
3 Slowly pull follower rod outward from
grease cylinder cap until groove is visible.
4 Engage groove in follower rod slot in
grease cylinder's cap.
5 Screw grease cylinder onto gun.
6 Disengage follower rod from slot in grease
cylinder cap.
7 Push follower rod into grease cylinder.
9

Loader pump

WARNING

Do not substitute with a high-pressure
grease fitting. Gun can be equipped with
an optional low-pressure loader fitting
322610.
Personal injury can occur due to
excessive pressure.
Use of a grease fitting will void warranty.
Failure to comply may result in serious
injury or death.
NOTE
Loader fitting on gun must mate with
loader coupler. Pump may not operate if
components are not compatible.
1 Pull follower rod and engage follower by
rotating rod.
2 Seat loader fitting into loader coupler.
3 Push down to hold coupler valve open.
4 Operate pump and view movement of
follower rod.
5 Discontinue pump operation once groove
on follower rod is visible.
6 Disengage follower rod from follower and
push into grease cylinder.