Alemite 3572-B Руководство по эксплуатации

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Блок управления Alemite 3572-B. Alemite 3572-B 4 страницы. High volume control valve

Печатать страницу

Description

CAUTION

Do not operate this valve with an antifreeze and water

mixture.

The control valve models included in the 3572 series are

designed to dispense a variety of fluids. These include engine

oils, diesel oils and hydraulic oils.

WARNING

Release all pressure within the system prior to

performing any overhaul procedure.

• Disconnect the air supply line from the pump

motor.

• Into an appropriate container, operate the control

valve to discharge remaining pressure within the

system.

Never point a control valve at any portion of your body

or another person. Accidental discharge of pressure

and/or material can result in personal injury.

Read each step of the instructions carefully. Make sure

a proper understanding is achieved before proceeding.

Assembly

Apply thread Sealant to the male threads on the extension

(1 or 2).

NOTE: Do not apply thread sealant to the first two

(2) threads. Contamination can occur.

Install the Extension into the Handle. Tighten securely.

Prime and Test

NOTE: Perform the following procedures at an air

pressure that allows the pump to begin to cycle.

Regulate the amount of air to the pump with a

pressure regulator.

671059

Service Guide

High Volume Control Valve

Alemite, LLC

167 Roweland Drive, Johnson City, Tennessee 37601

www.alemite.com

2014 by Alemite, LLC

Figure 1 High Volume Control Valve Model 3572-A

Fluid Inlet (Swivel)

Maximum Operating Pressure

Should valve leakage occur at anytime, refer to the

Troubleshooting Chart.

1. Point the control valve into an appropriate collection

container.

2. Allow the pump to deliver fluid to the control valve.

• The control valve should show no leakage nor dispense the

fluid.

3. Cycle the control valve Lever Assembly several times.

• Fluid should flow once air is eliminated from the control

valve (and system).

With the Lever in the released position, no fluid should

appear at the Nozzle.

If product does appear, refer to the Troubleshooting Chart.

The non-drip nozzle opens automatically when fluid is

dispensed.

After use, the nozzle should be manually pushed closed to

prevent oil drip.

3572-A

3572-B

3/4" NPTF (f)

1450 psi (100 bar)

SER 3572-A

Revision (8-14)