ARO 613104 Руководство по эксплуатации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Водяной насос ARO 613104. ARO 613104 6 страниц. Wash pump detergent pump assembly
Печатать страницуNo material (stalled pump).
• Obstructed (R) spray tip. Remove spray tip and clean.
• Obstructed (F) hose assembly. Remove control handle and operate
pump until line is clear.
• Obstructed (G) control handle assembly. Disassemble and clean.
No material (Pump continually cycles).
• Empty material supply. Disconnect the air. Replenish material sup-
ply. Connect the air. Open (G) control handle assembly until pump is
primed.
• 90609 Retaining screw (See Figure 3) disassembled from (3) plung-
er. (Figure 4). Connect the retaining screw to the plunger. (Follow
instructions for assembly of air motor to lower pump end).
• Damaged (H) lower suction tube. Replace suction tube.
• Loose (J) hose clamp assembly on (K) tube. Tighten clamp.
Material on One Stroke only (Fast Downstroke).
• (20) Ball in (21) foot valve not seating, or damaged (19) "O" Ring.
Remove the foot valve. Remove the ball from the foot valve. Clean
and inspect ball and foot valve. If either ball or foot valve is damaged,
replace, also replace (19) "O" Ring if damaged. (See Lower Pump
End Instructions).
Material on One Stroke only (Fast Upstroke).
• Worn (13) "O" Ring. Replace with new (13) "O" Ring. (See Lower
Pump End Instructions).
Material Leakage Out the Oil Daily Holes in Pump.
• Worn (5) packing. Replace worn packing. (See Lower Pump End In-
structions).
PAGE 6 OF 6
TROUBLE SHOOTING
OPTIONAL ACCESSORIES
61113 MOUNTING BRACKET
Air leakage out of the Main Exhaust.
• Worn 90796 valve insert. Replace the valve insert. (See Air Motor
Instructions).
• Loose 65027 Piston Assembly. Tighten piston assembly. (See Air
Motor Instructions).
• Damaged 65027 Piston Assembly. Replace piston assembly. (See
Air Motor Instructions).
• Warped or worn 65028 valve plate and pin assembly. Replace valve
plate and pin assembly.
Continual leakage out of the bleeder hole in the Head Assembly.
• Worn 91207 "O" Ring or 91007 Seal. Replace the "O" Ring and Seal.
(See Air Motor Instructions).
Air leakage out of the bleeder hole on the Air Motor Assembly
downstroke.
• Worn Y186-51 "U" cup. Replace the "U" cup. (See Air Motor Disas-
sembly Instructions).
Air leakage out of the Oil Daily Holes in the Pump Section.
• Worn Y325-210 "O" Ring. Replace the "O" Ring. (See Air Motor In-
structions).
Material leakage around the Control Handle.
• Loose 76947 gland. Tighten packing screw. (See Control Handle In-
structions).
• Worn 77516 packings. Replace packings. (See Control Handle In-
structions).
FIGURE 5
640081-B STRAP WRENCH
PN 97999-92
613100-X