3D Hobby Shop Velox VR-1 Руководство по сборке - Страница 14

Просмотреть онлайн или скачать pdf Руководство по сборке для Игрушка 3D Hobby Shop Velox VR-1. 3D Hobby Shop Velox VR-1 17 страниц.

The cowl is installed with 4 small wood screws which screw into 4 small square plywood pads at the

extreme front of the fuselage. Use small pieces of tape or paper as indicators to show the position of

these plywood pads after the cowl is on.

Install the canopy hatch (if the canopy hatch is not installed when you fit the cowl, it may be

impossible to fit the canopy hatch after the cowl is installed!).

You can use a 1/16" or smaller drill bit to drill these holes in the cowling, but the preferred method is to

spin a sharp hobby knife blade to make these holes as shown. This gives precise control of the size of

the holes and does not open the holes in the plywood pads too large.

Remove the cowl, use a drop of thin CA to harden the hole in each plywood cowl-mounting pad, and re-

install the cowl with 4 small wood screws.