Artison RCC 1000 Series Руководство по установке - Страница 8
Просмотреть онлайн или скачать pdf Руководство по установке для Усилитель Artison RCC 1000 Series. Artison RCC 1000 Series 12 страниц.
Печатать страницу1. Connect to either the Balanced Female XLR or Unbalanced Female RCA Inputs. NOTE: For best
performance, use a Y-Adapter when using the Unbalanced RCA.
2. Connect to the Unbalanced Female RCA Cascade Outputs to connect to another amplifier.
This signal will output at full bandwidth.
12 VOLT TRIGGER / IR INPUT
1. +12V Trigger Input – Connect a ⅛" MINIJACK to utilize the 12 volt trigger wire from your other
equipment, the polarity on the connector can be either way.
2. IR INPUT - Connect a ⅛" MINIJACK to control the RCC620-SA via an IR control system.
3.
IR REMOTE FUNCTIONS:
i.
ii.
iii.
iv.
v.
vi.
LOW PASS FILTER / PHASE CONTROL
1.
LOW PASS FILTER (LPF) – This is the crossover frequency setting of the Low Pass Filter. The unit
comes from the factory with the 80Hz setting that is recommended for use with Artison Front
Channels. If used in conjunction with any other speakers consult with the manufacturer for the
correct setting.
2.
PHASE CONTROL – The phase of the subwoofer can be adjusted to fine tune the signal
coincidence of the subwoofer and the lower frequencies of your LCR Speakers. The unit
POWER ON
STANDBY POWER
GAIN UP
GAIN DOWN
MUSIC EQ MODE
MOVIE EQ MODE
10110000011101 10010000011101
10110000000000 10010000000000
10110000011111 10010000011111
10110000100000 10010000100000
10110000100001 10010000100001
10110000111111 10010000111111
8