Asian Phoenix Resources PowerPal MHG-500LH Инструкция по использованию и уходу - Страница 9

Просмотреть онлайн или скачать pdf Инструкция по использованию и уходу для Портативный генератор Asian Phoenix Resources PowerPal MHG-500LH. Asian Phoenix Resources PowerPal MHG-500LH 13 страниц. Low head micro-hydroelectric generator

Печатать страницу

1. Read this First

7. Make sure that both the white dial and the red switch on the ELC are in the 'off'

position. Adjust the output voltage by turning the white dial until the voltmeter

shows a reading of 220V (photo A). Then turn the red switch to the 'on' position

(photo B). Commence testing by plugging in a light bulb or small appliance into

one of the sockets on the load controller (photo C). The appliance should now be

working properly and the test is complete. Unplug the appliance.

Avoid plugging appliances directly into PowerPal without using the load

controller. Incorrect voltage may result, which can damage your appliance.

8. Run the required length of two-strand, jacketed electrical cable from PowerPal to

your house etc. Use 3.75 Ampere wire (0.75 sq. mm / Amp) for both MHG-200

and MHG-500 models. This is thicker than is required but thinner wires are more

fragile. For the MHG-1000 model use 5 Ampere wire (1.0 sq. mm / Amp). Insert

the two-pin plug end into the socket on the generator part of PowerPal. Hang the

electronic load controller in a dry place inside the house and connect to the socket

end of the cable. Repeat the setup procedure for the ELC as above. You can now

plug lights and appliances directly into the load controller ready for use, with or

without additional house wiring. The voltage shown on the load controller should

still be 220V. The voltage needs only to be checked and adjusted if the water flow

rate changes. Heavy rain may increase the flow rate, or a prolonged dry period

may gradually reduce it. Check the voltmeter from time to time and adjust if

necessary.

CARE AND MAINTENANCE

General care for your PowerPal will enhance its life. Following the instructions in this

manual is important.

If flooding causes the inside of the generator assembly to become wet, remove the cap

and leave PowerPal in the sun to dry. No permanent damage will result, but check the

upper bearing to see if it has collected water. If so, turn PowerPal upside down to

drain and dry the internal shaft assembly. Do not try to dry it near a fire as the rotor is

bonded with epoxy that could be damaged by excessive heat. Before using again,

make sure that the power socket is also dry. Condensation inside the generator is

normal in tropical areas and will not effect the performance of PowerPal.

There is only one task that must be completed at regular intervals. This is greasing of

the upper bearing bearing assembly.

PowerPal™ Low Head 9