ACR Electronics RCL-75 Руководство по поддержке продукта - Страница 9

Просмотреть онлайн или скачать pdf Руководство по поддержке продукта для Заливающий свет ACR Electronics RCL-75. ACR Electronics RCL-75 20 страниц. Remote control searchlight system
Также для ACR Electronics RCL-75: Руководство по поддержке продукта (15 страниц), Руководство по поддержке продукта (20 страниц)

When the flush mount option is selected, cut a rectangular hole in the

dashboard location using the Point Pad™ Flush Mount Template

supplied in the Mounting Templates. Use the gasket, washers, nuts, and

the two U-Clamps provided to secure the Point Pad™. Use a sealant

around the cut out to protect from moisture intrusion.

Make sure there are no obstructions behind the area where the switch is

to be located. (i.e. bulkheads, wires, plumbing, hardware.) Check in

advance to verify the wiring harness can be routed to this location.

Figure 4-

Figure 5-

Point Pad™ surface mount

Point Pad™ flush mount

Mounting the Light

Make sure area is clean and dry. Decide on the use of screws or bolts.

Verify that the backside of the mounting surface can be reached to

install nuts and washers.

NOTE: If the mounting surface is not flat, a special, shapeable plate can

be purchased, (P/N 9427), to adapt the light base to the surface. This

plate can also be used to raise the light 1 inch (2.54 cm) if desired (see

Figure 6).

Y1-03-0158G