ASL INTERCOM PS 6379 Kullanıcı Kılavuzu - Sayfa 5

İnterkom sistemi ASL INTERCOM PS 6379 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ASL INTERCOM PS 6379 20 sayfaları. Six channel loudspeaker master station pro series

Sayfayı Yazdır

5.0

MAINS POWER

The PS 6379 may be connected to the mains power

outlet to which other audio equipment is connected. The

outlet should have a clean earth. Avoid using mains

power outlets, which also power dimmer controlled

lighting equipment.

Before connecting the unit to its AC power source, check

if the mains voltage of the unit (100 V – 240 V) is in

accordance with your local mains voltage.

WARNING

This appliance must be earthed

IMPORTANT

The wires in this mains lead are colour coded in

accordance with the following code:

green and yellow / safety ground

blue

/ neutral

brown

/ live

5.1

POWERING UP

Powering up procedure:

Make sure that the power switch at the back of

the unit is OFF.

Connect the power cord to the rear of the

station.

Plug the other end of the power cord into a

PROPERLY GROUNDED outlet.

5.2

SAFETY EARTHING

The green-and-yellow wire of the mains cord must always

be connected to the electrical installation safety earth or

ground. It is essential for personal safety as well as for

proper operation of the PS 6379 and the other connected

stations. This wire is internally connected to all exposed

metal surfaces. Any rack framework into which this unit

5.3

MAINS POWER SETTING

The unit has a switch mode power supply and accepts mains voltages from 100 – 240 VAC (50 / 60 Hz).

Mains Fuse

For all voltages : T 1250.

As the colours of the wires in the mains lead may not

correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire that is coloured green-and-yellow must

be connected to the terminal in the plug, which

is marked with the letter "E", or by the ground

symbol, or is coloured green.

The wire that is coloured blue must be

connected to the terminal that is marked with the

letter "N" or coloured black.

The wire that is coloured brown must be

connected to the terminal that is marked with the

letter "L" or coloured red.

Those units that are supplied to the North American

market will have an integral moulded 3-pin connector,

which is provided to satisfy required local standards.

Turn on the power with the red button. The red

overload LED will light up for about 3 seconds,

then extinguishes and the green power LED will

switch on, indicating the station is active.

For further installation and operation see the concerning

sections.

might be mounted shall be connected to the same

grounding circuit.

The PS 6379 employs professionally designed audio

input and output circuits which do not require the

disconnection of any safety earth for the avoidance of

hum loops.