ASL INTERCOM TS 10 Kullanıcı Kılavuzu - Sayfa 4

Kontrolör ASL INTERCOM TS 10 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. ASL INTERCOM TS 10 7 sayfaları. Cue light system

Sayfayı Yazdır
5.0
TS-120 FRONT PANEL CONTROLS
1
ATTENTION button
This push button activates the ATTENTION
signal for that specific channel
2
GO button
This push button activates the GO signal for that
channel
3
Indicator LED
This LED indicates the status of the channel (Off,
ATTN, Acknowledged or GO)
6.0
TS-120 REAR PANEL CONNECTORS
6
MAINS power switch
To switch the unit On and Off.
7
FUSE holder
The fuse in this holder needs to be a 1.25 A slow
blow type.
8
MAINS entrance
This MAINS entrance accepts any voltage from
100 - 240 V AC at 50-60 Hz.
9
LINK IN connector
To this Sub-D9 connector the TS-99 preset control
is connected. This connector is also for linking two
TS-120‟s : the TS Link Cable coming from another
TS-120 goes to this LINK IN connector
PAGE 4
User Manual TS 120 / March 2011 © ASL Intercom BV
.
4
All selected channels GO button
This push button activates the GO function for all
channels which are in Attention mode.
5
CLEAR button
With this button all channels which are in GO
mode can be switched off simultaneously;
it clears the channels for the next action. See also
section „internal Controls‟
10
LINK OUT connector
This connector is used for linking two TS-120‟s
(From this LINK OUT connector the TS Link Cable
goes to another TS-120)
The total cable length between all linked
TS-120‟s should not be more than 100 m.
11
XLR connectors
These twelve XLR-3 connectors are for
connecting the TS-10‟s
Pin assignments:
1.
0 V / ground shield
2.
+30 V power wire
3.
signalling line