AMCOL 6000P Operatör El Kitabı - Sayfa 9
Yağlama sistemleri AMCOL 6000P için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. AMCOL 6000P 19 sayfaları. Pneumatically controlled precision lubrication system
Sayfayı Yazdır6 Priming/Re-priming the System
1. Fill the reservoir.
2. Open the ball valve on the bottom of the reservoir.
3. Open pumps by turning the T60A liquid adjustment screw counterclockwise.
4. Repeatedly cycle the injectors.
5. Once liquid reaches the spray point, readjust the T60A Posi-pump to
the desired setting.
6. Adjust spray air pressure if necessary.
7 System Troubleshooting
Check in order as listed
Fluid Volume Inappropriate
Injectors misadjusted: adjust individual injectors.
•
Incorrect cycle timing: readjust Injection Pulse Rate.
•
Inconsistent Spray Volume to One Spray Point
Spray tip is clogged: simply remove, clean, and replace spray tip.
•
Spray tip is not properly attached: be sure spray tip is tightly threaded and secured,
•
and that the 1/8" liquid line is properly installed onto barbed connectors.
Spray tip is damaged: remove and replace.
•
Liquid or air hose is severed or incorrectly attached: reconnect or replace.
•
T60A Posi-pump needs to be rebuilt: see instructions on page 12.
•
Inconsistent Spray Volume to All Spray Points
Be sure the fluid reservoir ball valve is open.
•
Fluid level is low: refill reservoir.
•
Strainer on reservoir is clogged: clean or replace.
•
Mist or Fog
Manifolded dispensing air pressure set too high: adjust.
•
Individual spray point flow set too high: adjust.
•
Liquid from Back of Injector
Injector contact seals leaking: clean injector and replace O-ring.
•
6000P PNEUMATICALLY CONTROLLED PRECISION LUBRICATION SYSTEM
Operator's Manual
P A G E | 8