10Bar G10 Kullanıcı Kılavuzu - Sayfa 3

Kamera Aksesuarları 10Bar G10 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 10Bar G10 10 sayfaları. Camera underwater housing

(3) MODE DIAL - press down and turn to activate the required mode.

(4) ISO SPEED DIAL - press down and turn to adjust the ISO value.

(5) SHUTTER / ZOOM - press to activate the shutter, turn to activate the zoom function (separate controls on

some version).

(6) POWER ON/OFF - align the white dot towards the lid, press and turn on or off.

(7) PLAYBACK - press to activate.

(8) (AE LOCK/FE LOCK) / (MICROPHONE) BUTTON，(METERING LIGHT) / (JUMP) BUTTON，

(AF FRAME SELECTOR) / (SINGLE IMAGE ERASE) BUTTON - rotate until the white dot is over

the required button and press to activate.

(9) CONTROL DIAL –- press down and rotate to select.

(10) 4-Way BUTTON - rotate until the white dot align and press, when not in use rotate the white dot until

pointing downward to facilitate the 'Function Set' to be activated.

(11) FUNCTION. SET- rotate until the white dot align and press.

(12) DISPLAY / MENU- rotate until the white dot align and press.

(13) (SHORTCUT) / (PRINT / SHARE) - press down to activate the function.

For the full list of camera functions and settings accessed by each control, please consult the Canon G10

camera instruction manual.

4. Set up Instructions

4.1 Special note on responsibility for watertight integrity

Each housing is individually inspected and hydrostatically tested in the factory. The design of the main piston

O-ring seal is among the most reliable in the industry and the watertight integrity is excellent. This special

O-ring design provides a perfect seal even if there is any slight movement between the body and lid due to

change of ambient pressure. However please note that responsibility for ensuring the integrity of the watertight

seal lies entirely with the user. 10BAR accepts no liability for damage to, or loss of any equipment used with,

or placed inside the housing. Users are highly recommended to carry out in-water test of the housings without

installing of the camera for their first dive, after change of new ports or alternation of any new configuration.

The test can be carried out by lowering the housing with ballast to the working depth or dive down to the safe

diving range.

The O-ring seal is the main barrier between the water outside and the air space within the camera. It is

an effective barrier only if the seal is properly maintained. The O-ring seal should be inspected before

every dive. The following information is provided for guidance in using and maintaining the O-ring seal.