Aktobis WDH-1200HT Manuel - Sayfa 5

Kurutucu Aktobis WDH-1200HT için çevrimiçi göz atın veya pdf Manuel indirin. Aktobis WDH-1200HT 9 sayfaları. Building dryer

Instructions for use:

1. Commissioning

Insert the mains plug properly into the socket.

Make sure that the condensate (water) can drain off unhindered or that the hose connection is properly seated !

Switch on the unit with the "On/Off switch".

Now set your desired target humidity value between 30% and 90% or select continuous operation. To do this, press

the "button for lowering the target humidity value" (▼) or the "button for increasing the target humidity value" (▲),

as appropriate. Pressing briefly changes the target humidity value by 1% each time. By pressing and holding (1.5

sec.), the target humidity value can be set by fast forwarding.

A target value of below 30% humidity is indicated in the display with "CO" and signals that the building dryer is now

set to continuous operation !!!

After approx. 5 seconds of inactivity, the target humidity value goes out and the currently determined room humidity

is shown in the display.

Note: The construction dryer has an automatic memory function. In the event of a power failure, this function

ensures that the building dryer resumes operation where it was previously interrupted. All set values remain stored.

To protect the compressor, however, its switch-on process is delayed by approx. 3 minutes ! (Compressor light

flashes during this time).

2. Operating procedure

After the building dryer is properly connected to the socket, the backlight of the display panel lights up.

After switching on the unit (On/Off), the detail display in the control panel lights up automatically. The target

humidity value is already preset to 60% r.h. by default.

The unit is programmed so that the compressor switches on for dehumidification as soon as the selected target

humidity value has been exceeded by 3% points (of the current room value).

The compressor then switches off again automatically as soon as the target humidity value has been undershot by

3% points. The compressor is then switched on again in the same way, so that there is a tolerance of 6% points

between the automatic switch-on and switch-off.

After switching off the unit (On/Off), all functions switch off and all displays go out.

3. Operating instructions

If the current humidity is below the target humidity value, the unit does not switch on.

To protect the compressor, the unit should always run for at least 3 minutes or be switched off before you press the

On/Off switch again!

At cold ambient temperatures or icing in the unit, a sensor automatically controls a defrosting process. This is

indicated by the following defrost symbol (

in the display field at the top right). Meanwhile, the defrost mode

automatically controls the air circulation and the compressor operation!

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de