AerobTec Altis Micro Kullanıcı Kılavuzu - Sayfa 4

Ölçüm Cihazları AerobTec Altis Micro için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AerobTec Altis Micro 17 sayfaları. Recording / competition altimeter with telemetry

Sayfayı Yazdır

The device and the software also provide some other complementary functions such as temperature,

throttle or voltage measurement and recording.

The Altis Micro uses a modern, fast, digital pressure sensor which allows it to sense very low pressure

differences. This gives the unit an altitude resolution smaller than 0.5m with sample rates as low as 0.1s.

Since atmospheric pressure changes over time, these changes will affect your measurements. For this

reason, long term measurements may not be precise enough. However, the altitude for short term flights,

which are common in R/C aircraft, can be recorded very precisely. The measured altitude is stored in the

high capacity internal memory which allows approx. 15 hours of recording with the fastest sampling rate

(0.1s).

After the Altis Micro is connected to a power supply, it will initialize in the first 3s. During initialization, the

reference altitude and a zero throttle level are measured. Note: It is necessary to keep the throttle on

your R/C transmitter turned off during this phase. It is recommended to set the initial altitude

before each flight by disconnecting and re-connecting the power supply.

Your Altis Micro has 4 connectors. They are shown in Fig 1.

RC IN

RC OUT

USB

COM

AerobTec Altis Micro User Manual

– input signal from the R/C receiver. Power to Altis Micro is provided from

the receiver via this connector

– output signal to ESC (Electronic Speed Control)

– Connects the Altis Micro to a computer via USB

– Molex connector for connection with telemetry equipped receivers as well as

future additional features

Fig 1: Connectors of your Altis Micro