AerobTec Altis v4 Kullanıcı Kılavuzu - Sayfa 8
Ölçüm Cihazları AerobTec Altis v4 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AerobTec Altis v4 14 sayfaları. Recording/competition altimeter
Sayfayı YazdırWhen you connect the device to your aircraft, the Altis v4 informs you about the 3s initialization phase by
displaying the initialization screen. This screen also shows the firmware version and the serial number of
your device.
It is not recommended to disconnect the device when you see this screen.
This screen shows the firmware version and the F5J height as specified by FAI F5J rules.
The F5J height is indicates by 3 + 1 digit number. If there is no F5J detected or the motor was restarted, -
- - . - is shown on the screen instead.
This screen allows you to choose which information you would like to display on the screen. Please refer
to page 12 for more information.
When logging data, there are times when it is dangerous for the device to be disconnected. If the Altis v4
is disconnected at these times there is a danger of losing all your data in the device. This is indicated by
the "Do not disconnect screen". Do not disconnect the device when you see this screen!!!
It is not recommended to disconnect the device during the initialization screen, too.
When you connect your Altis v4 to a computer, the device stops its competition and logging functionality
and provides its data to the computer. This data is indicated by the USB mode screen.
AerobTec Altis v4 User Manual
8