AMERITRON SDC-105 Kullanım Kılavuzu - Sayfa 2
Kontrolör AMERITRON SDC-105 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AMERITRON SDC-105 11 sayfaları. Automatic screwdriver antenna controller for all transceivers
Sayfayı Yazdır
Introduction:
The SDC-105 Screwdriver Antenna Controller will automatically adjust the
screw driver antenna to the Transceiver's frequency. The controller senses RF
an automatically moves the antenna to the correct location. The controller has a
two speed motor control for reaching the desired location in less time. There are
no cables to connect to the transceiver. The controller gets its information from
the feed line RF sensor and the antenna's internal counter switch.
The antenna must have an internal sensor switch installed for the antenna
controller to operate properly. If your antenna does not have a sensor, contact
the antenna manufacture or Ameritron.
Features:
Automatic antenna tuning
2 Speed motor control
RF sense display
Frequency display
VSWR display
Current display
Antenna directional indicator
Manual UP/ DOWN buttons
Adjustable current sense trip for Antenna Motor Production
Antenna turns counter
Reverse polarity
Home
Operation controls
Power:
Up:
DOWN:
SETUP:
SKIP:
ENTER:
TUNE:
HOME:
INSTALLATION:
WARINGING: Do not reverse the polarity of the Red and Black wires.
Damage will occur to the controller.
1. The Red Power Wire needs to be fused to protect the controller and the
antenna. The fuse must be no larger than a 5 amp rating. Some antennas may
require a lower current rating. Refer to the antenna's manual for the current
Switches the controller's power on and off.
Moves the antenna up.
Moves the antenna down.
Allows programming of the antenna
Navigates thru the menus
Stores the menu setting.
Moves the antenna to a programmed setting for the displayed
frequency or fine tunes the antenna if RF is present.
Lowers the antenna all the way down and turns the motor off.
2