Akw 2842246 Kurulum Talimatları Kılavuzu - Sayfa 4

Sıhhi Tesisat Ürünleri Akw 2842246 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Akw 2842246 8 sayfaları. Shower tray

Sayfayı Yazdır

Installer Information

Specification

Tray height excluding waste: 26mm

•

Slate finish

•

Stainless Steel waste cover with slots

•

Concealed waste

•

Shallow depth waste

•

High water flow rate (30 l/min)

•

Weight load : 200kg

•

Impact resistant

•

Webbed back reinforcements

•

Material : SMC (Sheet Moulding Compound)

•

Placement

Suitable for 'on floor' or 'in floor' installations.

For wooden floor installation, use a suitable grab adhesive.

For solid floor installation, use a mix of 6:1 sand and

cement to secure the tray down into position. It is

recommended when removing solid floor material, to

remove a minimum depth of double the thickness of

the tray.

Ensure that the floor levels are tested before and

after the installation, water test the flow from tray into

waste for correct installation and drainage efficiency.

It is important to ensure that the floor is level in all

directions before putting the tray into place. If water

puddles away from the waste, this is a clear indication

that the levels are not correct. The water must drain

towards the waste.

The sides of the tray A and B may well show level on testing, but if point C is low, then water will

puddle in the area of point C and the only remedy is to level the floor and refit the tray. The tray has

'lands' on all four sides. Use a spirit level front to back and side to side - all 'lands' must be level

(ABC) - the fall is moulded into the tray.

Trimmable Trays

Trimmable to within 150mm of waste.

If trimming is absolutely necessary to avoid

obstructions or tricky installations then Onyx

trays can be trimmed down to within 150mm

of the waste cover area. The sides on the tray

X and Y shown are shaded out to show the

trimmable areas.

General: 01905 823 298