Ametek Gemco 1996 Ram-Set Kurulum ve Bakım Kılavuzu - Sayfa 14
Kontrolör Ametek Gemco 1996 Ram-Set için çevrimiçi göz atın veya pdf Kurulum ve Bakım Kılavuzu indirin. Ametek Gemco 1996 Ram-Set 20 sayfaları. Automatic press shut height controller
Example: To enter die number 1 and shut height of 10.000: STXZmmF1ED1E0000EEOT. To access data through the serial
port, the ENQ ($05) character must proceed entries.
Example: STXZmmENQF1ED1EEOT would cause the Ram-Set to return STXZbbACKF001D001 : 10000EOT.
If commands are strung together in the same transmission, ENQ must precede each function that data is being requested
from:
Command Symbols
D
($44)
E
($45)
F
($46)
K
($4B)
L
($4C)
P
($50)
:
($3A)
=
($3D)
After the Ram-Set has successfully received a message, it will transmit the following:
A.
If no data was requested and no data errors occurred, it will transmit
STXZmmACKEOT where mm is the last address.
B.
If data was requested, it will transmit STXZmm ACK (requested data) EOT.
C.
If an error occurred, it will transmit STXZmmNAK00xEOT.
The "x" in the above transmission represents an error code. The codes are detailed below:
Error Codes
1: Transmission error, over-run, framing or parity error
2: Receiver buffer overfl owed (256 characters max.)
3: Data format error (check control characters)
4: Data error (check data limits)
5: Signal error (function 8 offset can't be entered)
Pinout of D9 to any RS485 terminal
Host D9
1--------------------------------------------------------------------- GND -------------------------------------------------------------------------1
2--------------------------------------------------------------------- Data--------------------------------------------------------------------------2
3--------------------------------------------------------------------- Data--------------------------------------------------------------------------3
4--------------------------------------------------------------------- Data--------------------------------------------------------------------------4
5--------------------------------------------------------------------- Data--------------------------------------------------------------------------5
Represents the die # key
Represents the ENT key
Represents the F key
Used to request a program dump
Used to request a decimal position
Used to request a transducer position
Precedes returned function data
Requested data is unavailable
Installation and Maintenance Manual
Chapter 3: Programming and Operating Instructions
Ram-Set D9