Astro Pneumatic Tool 3036 Manuel - Sayfa 2

Sander Astro Pneumatic Tool 3036 için çevrimiçi göz atın veya pdf Manuel indirin. Astro Pneumatic Tool 3036 4 sayfaları. Air belt sander

Model:

1.) LUBRICATION:

Before connection of the hose, apply 4 to 5 drops of a good

quality air tool oil at the air inlet. After 3 to 4 hours of

operation, oiling may be necessary again.

2.) TIGHTNESS OF PARTS:

Regularly check whether all connection parts are

fastened securely. Follow this procedure daily

before beginning work.

3.) STORAGE:

Avoid storing the tool in a location subject to high humidity. If

the tool is left unused, the residual moisture inside the tool

can cause rust. Before storing and after operation, oil the tool

at the air inlet with a good quality air tool oil and run it for a

short period.

4.) DISPOSAL:

Follow national legislation of waste disposal.

5.) ORDERING SERVICE PARTS:

For further operational and handling information or for

replacement of parts and components, contact the sales

agent from where you purchased the tool, or the service

division of our company, phone number 800-221-9705.

*When ordering parts and components, give each part

number, name, and quantities.

Replacing The Sand Belt

Disengage and remove the sand belt from the idle pulley. Push the

idle pulley in the direction shown below. Replace a new belt.

WARNING

Keep your hands and all foreign objects away from the idle pulley.

Push tension bar indicated on the drawing and the sand belt

will be propped into the ready position.

Adjust Tracking

If the sand belt is not centered on the idle please follow direction

to center the belt. Adjust the hexagon socket head bolt on the idle

pulley bracket with accessory hexagon wrench key until centering

is correct. Turn the hexagon socket counter clockwise to move the

belt towards the bracket and vice versa.

3036

Product Type:

AIR BELT SANDER (10 x 330MM)

Also Sold Separately:

• 30361 - 10pc. Sanding Belt 80 Grit - 3/8" x 13" (10mm x 330mm)

• 30362 - 10pc. Sanding Belt 100 Grit - 3/8" x 13" (10mm x 330mm)

• 30363 - 10pc. Sanding Belt 120 Grit - 3/8" x 13" (10mm x 330mm)

Page 2