Astro Tool M22520/40-01 Montaj - Sayfa 2

Kıvrım aleti Astro Tool M22520/40-01 için çevrimiçi göz atın veya pdf Montaj indirin. Astro Tool M22520/40-01 6 sayfaları. For terminals, splices, and endcaps

Sayfayı Yazdır

GENERAL DESCRIPTION

The AMT4001 crimp tool has color coded handles

to help match the color of the terminal, splice, or

endcap being crimped with the correct crimp

cavity. Additional color code information is on the

tool's side plate.

The AMT4001 has an adjustable insulation crimp

cavity that can be set at any one of four height

settings depending on the insulation diameter of

the terminal, splice, or endcap and wire to be

crimped.

The spring loaded locators assist in correctly

positioning the terminals, splices, or endcaps in

the crimp cavity.

The AMT4001 incorporates a tamper proof double

action ratchet that once engaged will not release

until the handles are closed fully and the crimp

completed.

HANDLE AND DOT COLOR CODES

Note that the tools handles are color coded for

the size terminal, splice, or endcap being

crimped. The color coded terminal, splice, or

endcap should be crimped in the corresponding

colored cavity. For example, when crimping red

coded insulated terminals the red/yellow crimp

cavity on the red handle side of the tool should

be used.

______________________________________________________________________________________________

TI4001

ASTRO TOOL CORP.

CONNECTOR ASSEMBLY TOOLING

21615 SW T-V Hwy, Beaverton, OR 97006 USA

Phone: 503-642-9853 Fax: 503-591-7766

CRIMPING PROCEDURE

1. Strip wire to the dimension specified by the

terminal, splice, or endcap manufacturer.

2. If the die cavity is not already open, close

the tool handle until the ratchet releases

and the die cavity opens.

3. Place the color coded terminal, splice, or

endcap into the proper cavity of the crimp

dies, so that the terminal tongue slides

under the locator, the splice window slides

under the locator, or endcap end rests

against the recess in the locator.

4. Close the tool handles until the terminal,

splice, or endcap is held in place, but not

crimped.

5. Insert the stripped wire into the terminal

until the conductor butts against the

locator. Or insert the stripped wire into

the splice or endcap until the conductor

butts against the internal stop of the splice

or endcap.

6. Hold the wire in position and complete the

crimp by closing the handles fully until the

ratchet releases.

7. If crimping a splice, rotate splice 180

degrees and repeat steps 3-6.

Page 2 of 6

Astro Tool Corporation

REV. A

7-9-08