ASTRO-MED Dash 16u Hızlı Başlangıç Kılavuzu - Sayfa 7

Ölçüm Cihazları ASTRO-MED Dash 16u için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. ASTRO-MED Dash 16u 13 sayfaları. Field and lab recorder

[EXTERNAL]
[CLOCK]
Once you have set up the analog, data capture and trigger parameters, you can press the [ARM] button (near the encoder
wheel) to start a data capture record. The Dash 16u will be ready for the trigger to complete the record.
Once a data capture record is complete, several things can be done with the data. It can be reviewed on the color display,
played back to the chart paper, copied to the Zip disk or sent to a computer by ethernet.
[SCREEN PREVIEW]
[SETUP PLAYBACK]
Throughout the setup of the Dash 16u, you can use the Help sheets to guide you. The System Report and Chart Report
provide much useful information. The manual gives details on the keystrokes to achieve what you want to do with the
Dash 16u. The above lists the basics of the Dash 16u. Under many of the menus are additional choices for more
advanced capabilities of the Dash 16u.
Should you require additional assistance, you can contact our Technical Support Department toll-free at 800-343-4039 or
For window, level and slope triggering, percentage values are listed. This
percent value is with respect to the edge-to-edge location on the chart where 0%
is the bottom of the chart, 50% is the middle of the chart and 100% is the top of
the chart. Knowing the signal placement on the chart from analog setup, you can
pick the appropriate percentage level. See exercises in Section 9 for use of
waveform triggering.
Allows TTL or switch closure to ground trigger (see utility port pin-out).
Produces a trigger at pre-defined periods. For example, if it is set to one hour,
then every hour there will be a trigger. Also, you can set a one-time trigger at a
pre-defined date and time.

8. DATA REVIEW

[MODE] [DATA RECORD REVIEW] [SCREEN PREVIEW]
Part or all of the data can be acted upon. To help decide what part of the data is
of interest, the color display allows preview of the data record.
In the screen preview, there are two cursors (A, B) for selecting data. You can
page forward and backward through the data as well as expand or compress the
time base. The lower part of the display shows the time and amplitude
measurements.
Once you have selected data of interest, you can print the screen to chart paper,
create a .BMP file on Zip disk, or play out the data to the chart paper.
[MODE] [DATA RECORD REVIEW] [SETUP PLAYBACK]
For playing the data to the chart paper, there is a dedicated set up menu.
Here is where the format for playback is selected (one of the four charts,
numeric, X-Y plot). Also, you can select how much of the data to play back and
whether to compress or expand the timebase.