ASTRO-MED DASH II Hızlı Başlangıç Kılavuzu - Sayfa 4

Ölçüm Cihazları ASTRO-MED DASH II için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. ASTRO-MED DASH II 8 sayfaları.

SECOND SCREEN OF THE MAIN MENU
Trig
Ctrl
Press the softkey below "Disk I/O." The Disk I/O menu will appear.
DISK I/O MENU
File
Mgmt
Place a DOS formatted, 3.5" floppy disk into the disk drive on the front panel of the Dash II.
Press the softkey below "Syst File." You will have the option to save, load, execute and go back to the
previous menu.
Press the button below "Save" and rotate the encoder wheel until the flashing file name reads:
"DASH2_xx.NEW" where xx designates the file number and can range from 01 to 99.
Press the softkey below "EXEC" to save the setup configuration file. Notice that the file extension
changes from .NEW to .CFG.
To load a system configuration file from a floppy disk:
Place a disk containing the desired setup file into the disk drive on the front panel of the Dash II.
From the Disk I/O menu, press the softkey below "Syst File."
Press the softkey below "Load" and rotate the encoder wheel until the desired setup file is flashing on
the screen. The file name should read "DASH2_xx.CFG" where xx designates the file number.
Press the softkey below "EXEC" to load the file into the recorder.
5. SETTING UP ZERO AND GAIN
The [CH1] and [CH2] keys (Channel 1 and Channel 2) are used to set a variety of parameters, including:
turning each channel on/off, selecting a voltage sensitivity for a channel, selecting a location for the input
zero position, suppressing a DC component of the waveform input, choosing between RMS and peak to
peak recording modes, grounding the input signal, selecting between standard voltage inputs and bridge
inputs, selecting filters and calibrating each channel.
Press the [CH1] key. The Channel 1 menu will appear. Note: The channel 2 menus and operations are
identical to those of Channel 1.
CHANNEL 1 MENU
1 - DC
Sens
The first line shows the channel status. In the above example, channel 1 is in DC mode at a sensitivity of
5.0 volts full scale.
SENSITIVITY In the new generation DASH II recorder, voltage is expressed in reference to full scale.
Since signal size is independent of grid size, a finer or coarser view of the signal data can be obtained by
adjusting channel sensitivity.
Capt
Plbk
Cnfg
Cnfg
Syst
Recd
File
File
5.0 V fs
ZS
Disk
I/O
More
Pos