Astrolite WARRIOR 360 Kullanıcı Kılavuzu - Sayfa 10

Kontrolör Astrolite WARRIOR 360 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Astrolite WARRIOR 360 13 sayfaları.

Note:

In making the lighting effects, the LED indicators of the irrelevant sliders should be off. If not, you can

press and hold Release and then push the slider to release them. Any channel with output value will be

stored into the chase.

VIII. Run a Chase

Step

Select one of Chase1 and Chase2, in which the desired chase is in.

The LED indicator of the number button with an existing chase will flash rapidly.

Select the desired number button to run the chase. The LED indicator will slow down the

flash, which means that the chase is now running. If more chases are running

simultaneously, then the LED indicator of the previous running chase number button will

stop flashing.

Note:

Different flashes of the number button LED indicator means different status. Rapid flash means that there

is an existing chase in the number button but not running. Full on means the chase is running and not for

editing. Slow flash means the chase in running and ready for editing.

The followings can be edited when the chase is running:

Press =>/SETY

Press <=/SETX

Press Auto

Press Music

Press ALL

Press Clear and hold for about 1 second to close all chases.

If the running chase and the manual control are using the same channel, only the manual output will be sent.

IX. Create a Chase Group

The controller can store up to 18 chase groups, each group with up to 36 steps. The running time of each step can be

adjusted from 0.5 second to 10 minutes.

To create a chase group, please follow the steps below:

Step

Press Program to enter programming mode

Select Group

Select a number from 1--18 as the number of the chase group. If the LED indicator of the

number button is on, it means there is an existing chase group in it.

Once the number button is selected, it will immediately jump to Chase1 for chase

Description

Chase runs forward

Chase runs backward

Chase runs under auto mode

Chase runs under sound activation mode

Then adjust X/Speed (function wheel) to adjust the running speed. Y/

Slope is for slope adjustment.

If ALL is not pressed, the adjustment is for the speed/slope of a single

scene step. Before adjustment, please make sure E/XY is inactivated

(LED indicator off).

Description