Asus 90MB10C0-M0EAY0 Manuel - Sayfa 11

Anakart Asus 90MB10C0-M0EAY0 için çevrimiçi göz atın veya pdf Manuel indirin. Asus 90MB10C0-M0EAY0 29 sayfaları.
Ayrıca Asus 90MB10C0-M0EAY0 için: Hızlı Başlangıç Kılavuzu (2 sayfalar)

Sayfayı Yazdır

ATX power connectors (24-pin EATXPWR, 8-pin EATX12V)

These connectors are for ATX power supply plugs. The power supply plugs are

designed to fit these connectors in only one orientation. Find the proper orientation

and push down firmly until the connectors completely fit.

•

CPU and chassis fan connectors; AIO pump connector (4-pin CPU_FAN,

4-pin CHA_FAN1/2/3; 4-pin AIO_PUMP)

Connect the fan cables to the fan connectors on the motherboard, ensuring that the

black wire of each cable matches the ground pin of the connector.

Do not forget to connect the fan cables to the fan connectors. Insufficient air flow inside

the system may damage the motherboard components. These are not jumpers! Do not

place jumper caps on the fan connectors! The CPU_FAN connector supports a CPU fan

of maximum 1A (12 W) fan power.

AMD AM4 CPU socket

This motherboard comes with an AMD Ryzen™ 2nd Generation/ Ryzen™ with

Radeon™ Vega Graphics/ Athlon™ with Radeon™ Vega Graphics/ Ryzen™ 1st

Generation processors.

For more details, refer to Central Processing Unit (CPU).

DDR4 DIMM slots

Install 2 GB, 4 GB, 8 GB, and 16 GB unbuffered DDR4 DIMMs into these DIMM sockets.

For more details, refer to System memory.

Aura RGB Strip headers (4-pin

RGB_HEADER1/2)

These headers are for RGB LED

strip.

The RGB header supports 5050

RGB multi-color LED strips

(12V/G/R/B), with a maximum

power rating of 3A (12V), and no

longer than 3 m.

Chapter 1: Product introduction

For a fully configured system, we recommend that you use a power supply unit

(PSU) that complies with ATX12V Specification 2.0 (or later version) and provides a

minimum power of 350 W. This PSU type has 24-pin and 8-pin power plugs.

DO NOT forget to connect the 8-pin EATX +12V power plug. Otherwise, the system

will not boot up.

We recommend that you use a PSU with higher power output when configuring a

system with more power-consuming devices or when you intend to install additional

devices. The system may become unstable or may not boot up if the power is

inadequate.

RGB_HEADER

PIN 1

+12V G R B

1 2 V

1-2