Dafra DRPB48 Kullanım Kılavuzu - Sayfa 7
Araçlar Dafra DRPB48 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Dafra DRPB48 10 sayfaları. Pneumatic blind rivet setting tool
Sayfayı YazdırDRPB48 Operation Manual
8) Place the clamping sleeve (#3) with the 3-jaw set (#4) inside it onto the assembly pusher
(#5) and ensure it is assembled firmly;
9) Replace the front sleeve (#2) and nosepiece (#1) on the tool;
TROUBLE SHOOTING
Problem
Rivet mandrel does not break
Jaws slippery on rivet mandrel
Rivet mandrel cannot be put into
nosepiece
Possible Causes
3-jaw set worn off or damaged.
Hydraulic oil in tool not sufficient.
Air supply with low pressure.
3-jaw set worn out.
Metal chips between jaws.
Pusher spring fatigued.
Incorrect nosepiece size chosen.
Jaws get stuck by mandrel not being
released.
Solutions
Change 3-jaw set.
Refill hydraulic oil.
Increase air supply pressure
within the specified range.
Change 3-jaw set.
Clean the jaws.
Change pusher spring.
Use correct size nosepiece
for rivet.
Remove any jammed
mandrels by disassembling
front sleeve and clamping
sleeve.