Follett U300BR800A/W Kullanım Kılavuzu - Sayfa 8
Buz Yapıcı Follett U300BR800A/W için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Follett U300BR800A/W 17 sayfaları. U300/ud300 series ice and beverage dispensers
Ayrıca Follett U300BR800A/W için: Kurulum Kılavuzu (12 sayfalar)
Sayfayı YazdırGate assembly removal
1. Remove black dispense chute cover.
2. Remove thumbscrews on each side of focus chute and remove.
3. Remove quick release pins holding dispense gate assembly
and chute.
4. Lift gate up and over hinge tabs, then carefully pull and tilt to
unhook from solenoid link.
5. Pull ice chute toward you to unclip from dimples on chute
mounting bracket.
6. Pull ice chute and gate toward you and out through panel opening.
Auger and auger tube removal
1. Remove black dispense chute cover, focus chute, dispense chute
and gate assembly.
2. Remove drain pan.
3. Remove thumbscrews from splash guard and remove.
4. Remove thumbscrews from splash panel; lift and pull forward at base
of panel and remove.
5. Unplug auger motor at electrical box.
6. Remove two 1/4-20 bolts holding auger motor to holddown
bracket.
7. Remove two thumbscrews from auger motor stabilizer bracket
and aside.
8. Lift auger motor off.
9. Remove dispense chute mounting bracket assembly.
10. Remove side panel of tower.
11. Remove screw holding top auger tube ring to lower ring.
12. Lift auger out of auger tube.
13. Lift out auger tube, turning as needed to clear rivnuts on side
auger motor mounting bracket.
Dispenser wheel removal
1. Remove dispenser top and turn power
switch OFF.
2. Remove drain pan and ice bin access
cover below it.
3. Remove splash guard and wheel motor access cover.
4. Remove all ice from bin.
5. Unplug wheel motor at electrical box and remove ground wire.
5. Remove wheel motor by
pulling out two quick release pins.
6. Lift drive shaft up through
hole in countertop.
7. Lift dispense wheel out
through drain pan opening.
gate assembly
auger
tube ring
drive
shaft
fixed yoke
rods with
brackets (front
rod is lowest)
8
Dispense chute assembly
quick release pins
springs
mounting
ice chute
bracket
U300 cutaway – front view
auger motor
auger tube
auger
Front
gate assembly
ice chute
wheel motor
fixed ramped
yoke rod with
bracket (below
rotating drive
bar)