Amprobe TIC 300 PRO Kullanıcı Kılavuzu - Sayfa 13

Ölçüm Cihazları Amprobe TIC 300 PRO için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Amprobe TIC 300 PRO 18 sayfaları. Meet the new standard in non-contact, high voltage detection
Ayrıca Amprobe TIC 300 PRO için: Kullanıcı Kılavuzu (15 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar)

Sayfayı Yazdır

MAINTENANCE AND REPAIR

If the TIC 300 PRO will not turn on, check the battery.

If there appears to be a malfunction during the

operation of the voltage detector, the following steps

should be performed in order to isolate the cause of the

problem:

1. Check the battery.

2. Review the operating instructions for possible

mistakes in operating procedure.

Except for the replacement of the battery, repair of

the voltage detector should be performed only by a

Factory Authorized Service Center or by other qualified

instrument service personnel. The front panel and

case can be cleaned with a mild solution of detergent

and water. Apply sparingly with a soft cloth and allow

drying completely before using. Do not use aromatic

hydrocarbons or chlorinated solvents for cleaning.

Battery Replacement

Use phillips blade screwdriver to remove the battery

hatch screw. Lift the hatch. Remove the battery and

replace it with a 9 volt alkaline battery. Make sure the

seal is in place. Close the battery hatch and replace the

screw.