Air King VS80 Kurulum Talimatları - Sayfa 2
Elektrikli Süpürge Air King VS80 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Air King VS80 2 sayfaları. Central vacuums
Ayrıca Air King VS80 için: Kullanıcı El Kitabı (12 sayfalar), Kurulum Talimatları (2 sayfalar)
Sayfayı Yazdır
pic. 10
When connecting the piping system to the VS80 power unit utilize the clamp collar ( Picture # 10 ). Important: Do not glue the clamp
collar to the machine. Press the screw clamp end of the clamp collar onto the inverted bag entry port. be sure to press it on until the
gap in the collar is completely closed off by the by the entry port stem. ( Picture # 11 ) and ( Picture # 12 ). Once in place tighten the
clamp collar until firmly seated to the entry port collar.
pic. 13
Your VS80 power unit is supplied with a 12" muffler
( Pic. # 15 ) and a 45 degree spigot coupling that is to be
connected in line to the air discharge port at the top of your
VS80 power unit. Push the 45 degree spigot coupling onto
the exhaust port at the top of The VS80 machine. Important:
Do not glue this coupling in place. ( Picture # 16-17 )
Connect the low
volt wire from your
piping system to the
two spade crimp
connectors on the
side of the machine.
(Picture # 20)
pic. 20
Check each valve in the home to insure system activation through your hose and the system operates as intended.
pic. 11
pic. 15
pic. 18
pic. 12
Once the entry port collar is in place you are free to
connect, glue, the piping system from your home to the
vacuum. be sure to apply solvent to a clean cut end pipe
end not to the inside of the clamp collar to prevent adhe-
sive from entering the throat of the piping system. (See
Pictures # 13, # 14)
pic. 14
You can then connect the muffler directly to the spigot
end of the coupling or use a 90 degree sweep to direct
the exhaust and muffler up from the machine further
dampening noise. ( Picture # 18 ) ( Picture # 19 )
pic. 19
Once your VS80 power unit is fully installed connect the
power to the machine. You can confirm the unit is powered
by the activation of the LED on the side of the machine. You
can confirm machine operation by using the on-off switch
located near the top of the power unit ( Picture # 21 ). note:
The power switch on the side of the unit is wired for opera-
tion of the machine independent of the low volt wiring circuit
to permit machine operation should a fault occur in your low
volt wiring circuit or the related control board and you are
waiting for service.
pic. 21
pic. 16
pic. 17