Advanced Diagnostics AD90 Kullanım Kılavuzu - Sayfa 9

Disk Çoğaltıcı Advanced Diagnostics AD90 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Advanced Diagnostics AD90 18 sayfaları. Transponder duplicating system

Sayfayı Yazdır

www.OBD2express.co.uk

3.0 CRYPTO TRANSPONDER

INTERFACE

NOTE: Before starting the copying procedure, please make sure that your

AD90 software version is 3.14 or higher. If not please contact your distributor

for assistance.

Connect the hardware together as shown below.

1. Connect the power supplies to the AD90 and the Crypto Transponder

Interface. The green and red LEDs will illuminate for one second and then

extinguish.

NOTES:

i) If non-original power supplies are used for the AD90 or the Crypto

Transponder Interface the warranty will be invalid.

ii) Please check that there is nothing that may short circuit the devices when

they are connected to the power supplies.

2. Insert the key into the AD90 key reader.

3. Press the 'Read' key on the Crypto Transponder Interface, the green LED

will illuminate and will remain on throughout the reading procedure.

4. Once the transponder code has been recorded, the green LED will start to

flash. Remove the original transponder from the AD90 and insert the new

transponder/key into the AD90 key reader.

5. Press the 'Write' key on the Crypto Transponder Interface, the green LED

will illuminate and will remain on throughout the writing procedure.

6. Once the copying procedure is completed, the green LED will extinguish and

the key/transponder can be removed from the key reader.