Alen C425 Kullanıcı El Kitabı - Sayfa 13

Klima Alen C425 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Alen C425 14 sayfaları. Alen c425: user guide

Alen C425 Kullanıcı El Kitabı
TROUBLES
1. UNIT DOES NOT
START WHEN
PRESSING
BUTTON
2. NOT COOL ENOUGH
3. POWER SHUT OFF AT
HEATING MODE
4. NOISY OR VIBRATION
5. GURGLING SOUND
6. COMPRESSOR DOES NOT
WORK AND THE DIGITAL
DISPLAY AREA SHOWS
P2

TROUBLE SHOOTING

POSSIBLE CAUSES
- Water full indicator blinks, water tank
is full.
- Room temperature is higher than
the set temperature.(Heating mode)
- Room temperature is lower than
the set temperature.(Cooling mode)
- The windows or doors in the room
are not closed.
- There are heat sources inside the
room.
- Exhaust air duct is not connected or
blocked.
- Temperature setting is too high.
- Air filter is blocked by dust.
- The automatic over heat protection
function. When the temperature at
O
the air outlet exceed 70 C/158 F,the
de vice will st op.
- The ground is not level or not flat
enough.
- The sound comes from the flowing
of the refrigerant inside the
air-conditioner.
- The bottom tray is full
SUGGEST REMEDIES
Dump the water in the water tank.
Reset the temperature.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if possible.
Connect the duct and make
sure it can function properly.
Decrease the set temperature.
Clean the air filter.
Switch on again after the unit has cool down.
O
Place the unit on a flat, level
ground if possible.
It is normal.
Remove the bottom drain plug and drain
the water outside.
11